Launching Parts Wizard application on your Scanner
Launching Parts Wizard application on your Scanner
Please scroll to the scanner that matches your model.
PPT (Windows):
Remove the scanner from the cradle and do the following:
Do a 3-button push by holding down either yellow button on the side, the green enter key, and the blue function key at the same time. Continue holding down these buttons until you see a screen flash and display PPT8800, then release the keys. This will restart the scanner and launch you into PartsWizard after a few seconds.
Janam XG300 (Windows):
Hold down the red power button, located on the left side of the scanner at the very top, until you get the menu options for Hard Reset, Soft Reset, and Power Off. Select Soft Reset. The scanner will now reboot and launch into PartsWizard on startup.
MC55 (Windows):
Hold down the red power button, located on the bottom left of the keypad, until the screen turns off. The scanner will now reload into PartsWizard.
Janam XG200 (Android):
Remove the scanner from the cradle, this should force the scanner to launch into PartsWizard. However, if it does not, navigate to the homepage and select the ScanWizard Icon.
XT30 & XT40 (Android):
Remove the scanner from the cradle and click on the "Start Scanning" button. The scanner will automatically launch into Partswizard.
If the scanner isn't on the page, you can launch into the app manually by clicking on the 'ScanWizard' app icon.